How To Clean The Doll’s Mouth, Vagina, and Anus

　　It’s extra important to clean your doll’s holes properly to prevent bacteria and mold from growing inside.

　　There are a couple of ways to clean out your doll’s holes – using either an irrigation tool or sponge swabs:

Using An Irrigation Tool

　　1.If you’re using a vaginal irrigator that doesn’t connect to a tap, simply fill it up with water first and place the irrigation end inside your doll’s holes. Some water might spill out during this step, so you may want to place a towel underneath your doll or wash it in the bath or shower.

　　2.Turn on the tap or start squeezing the irrigator to flush out your doll’s holes.

　　3.Fill the hole completely with water then hold the doll so that the water naturally falls out with gravity. You might need to give your doll a little shake to remove all the water.

　　4.Insert a dry sponge swab or tampon to get rid of any excess water.

Using Sponge Swabs

　　1.Dip your sponge swab in warm water and coat it with antibacterial soap.

　　2.Insert the swab into the hole and rub the area gently to remove any dirt.

　　3.Throw away the swab and repeat steps 1 and 2.

　　4.After two rounds of swabbing and cleaning, the holes should be ready to dry off. You can do this by inserting another drys。